Toyota Yaris: Turn signal lever - Driving procedures - When driving - Toyota Yaris XP130 2010–2025 Owner's ManualToyota Yaris: Turn signal lever

The turn signal lever can be used to show the following intentions of the driver:

Right turn

Left turn Right turn

Lane change to the right (push and Left turn

hold the lever partway) Lane change to the right (push and hold the lever partway)

The right hand signals will flash until you release the lever.

hold the lever partway) Lane change to the left (push and hold the lever partway)

The left hand signals will flash until you release the lever.

■Turn signals can be operated when

The engine switch is in the “ON” position.

■If the indicator flashes faster than usual

Check that a light bulb in the front or rear turn signal lights has not burned out.

    Manual transmission
    ■ Shifting the shift lever Fully depress the clutch pedal before operating the shift lever, and then release it slowly. If it is difficult to shift in reverse, shift the shift lever to N, r ...

    Parking brake
    To set the parking brake, fully pull the parking brake lever while depressing the brake pedal. To release the parking brake, slightly raise the lever and lower it completely while pressing th ...

    See also:

    General maintenance
    Listed below are the general maintenance items that should be performed at the intervals specified in the “Owner’s Warranty Information Booklet” or “Owner’s Manual Supplement/Scheduled M ...

    Installing child restraints
    Follow the child restraint system manufacturer’s instructions. Firmly secure child restraints to the rear seats using the LATCH anchors or a seat belt. Attach the top tether strap when installin ...

    Body panel anti-rust agent (wax) application areas
    HINT: 1) Apply anti-rust agent (wax) around the hinges whenever adjusting the doors and hoods. 2) Even if partially repairing a part, apply anti-rust agent (wax) over the entire application area ...