Toyota Yaris: Floor side rail front panel (ASSY)
REPLACEMENT
With the body lower back panel removed.
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram) Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
After welding, apply the polyurethane foam to the corresponding parts.
After welding, apply body sealer and under-coating to the corresponding parts.
After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.
Quarter panel upper extension (CUT)
REPLACEMENT
With the back door opening trough removed.
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordance
with the body dimension dia ...
Rear floor pan (ASSY)
REPLACEMENT
With the body lower back panel and floor side rail front panel removed.
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordanc ...
See also:
Your responsibility for maintenance
It is the owner’s responsibility to make sure that the specified maintenance
is performed. Section 6 gives details of these maintenance requirements. Also included
in Section 6 is general mainte ...
Engine compartment
Fuse boxes (→P. 275)
Engine oil filler cap (→P. 245)
Battery (→P. 250)
Brake fluid reservoir (→P. 249)
Radiator (→P. 248)
Condenser (→P. 248)
Electri ...
Body panel sealing areas
HINT: 1) Prior to applying body sealer, clean the area with a rag soaked in silicone
remover.
2) If weld-through primer was used, first wipe off any excess and than coat with
anti-corrosion prime ...