Toyota Yaris: Engine coolant temperature indicator and warning light
With tachometer
Without tachometer
1. Low engine coolant temperature indicator light.
2. High engine coolant temperature warning light.
The indicator and warning lights indicate the engine coolant temperature when the ignition switch is on. The engine operating temperature will vary with changes in weather and engine load.
The high engine coolant temperature warning light will come on when the ignition key is turned to the “ON” position. After a few seconds, the light will go off.
If your engine coolant temperature is cool with the ignition switch on, the low engine coolant temperature indicator light comes on. If it keeps lighting on with the engine fully warmed, contact your Toyota dealer as soon as possible to service the vehicle.
If the high engine coolant temperature warning light flashes, your engine is too hot. If your vehicle overheats, stop your vehicle and allow the engine to cool.
Your vehicle may overheat during severe operating conditions, such as: Driving up a long hill on a hot day.
Reducing speed or stopping after high speed driving.
Idling for a long period with the air conditioning on in stop-and-go traffic.
Towing a trailer.
NOTICE.
Do not remove the thermostat in the engine cooling system as this may cause the engine to overheat.
The thermostat is designed to control the flow of coolant to keep the temperature of the engine within the specified operating range.
Do not continue driving with an overheated engine. See “If your vehicle overheats”.
Fuel gauge
With tachometer
Without tachometer
The gauge works when the ignition switch is on and indicates the approximate
quantity of fuel remaining in the tank.
Nearly full—Indicator at “F ...
Tachometer
The tachometer indicates engine speed in thousands of rpm (revolutions per
minute). Use it while driving to select correct shift points and to prevent engine
lugging and over-revving.
Driving ...
See also:
Quarter wheel housing outer panel (ASSY): Hatchback
REPLACEMENT
With the quarter panel removed.
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordance
with the body dimension diagram. ...
Replacing light bulbs
The following illustrations show how to gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and light switch are off. Use bulbs with the
wattage ratings given in the tab ...
Front fender mounting bracket (ASSY)
REPLACEMENT
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordance
with the body dimension diagram. (See the body dimension diagram) Inspe ...