Toyota Yaris: Body panel sealing areas
HINT: 1) Prior to applying body sealer, clean the area with a rag soaked in silicone remover.
2) If weld-through primer was used, first wipe off any excess and than coat with anti-corrosion primer before applying body sealer.
3) Wipe off excess body sealer with a rag soaked in silicone remover.
4) Besure to repair as necessary if the body sealer shows signs of damage such as peeling or cracking.
1. ENGINE COMPARTMENT
2. INSIDE
3. OUTSIDE
4. DOOR PARTS
Paint coating
...
Body panel under coating areas
HINT: 1) First wipe off any dirt, grease or oil with a rag soaked in silicone
remover.
2) Cover the surrounding areas with masking paper to avoid coating unnecessary
areas. If other areas are acc ...
See also:
Rear floor pan extension (ASSY): Sedan
REPLACEMENT
With the body lower back panel removed.
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordance
with the body dimension diagra ...
Front fog lights
To turn on the front fog lights, twist the band of the headlight and turn
signal switch lever. They will come on when the head lights are on low beam.
...
If you cannot increase engine speed
If engine speed does not increase when the accelerator pedal is depressed, there
may be a problem somewhere in the electronic throttle control system.
At this time, vibration may occur. However, if ...