Toyota Yaris: Clock
With tachometer
Without tachometer
The digital clock indicates the time.
To adjust the clock, put the key in the “ON” position.
With tachometer—
Pushing the reset knob flashes the indicator for the hour and you can adjust the hour.
Press the reset knob until the desired hour will appear.
After 5 or more seconds pass without operating, the indicator for the minute flashes. Then you can adjust the minute.
Press the reset knob until the desired minute will appear.
After 5 or more seconds passes without operating, the indicator will return to the normal display.
If the electrical power source has been disconnected from the clock, the time display will automatically be set to 1:00 (one o’clock).
Without tachometer—
Pushing the reset knob flashes the indicator for the minute and you can adjust the minute.
Press the reset knob until the desired minute will appear.
After 5 or more seconds pass without operating, the indicator for the hour flashes.
Then you can adjust the hour.
Press the reset knob until the desired hour will appear.
After 5 or more seconds passes without operating, the indicator will return to the normal display.
If the electrical power source has been disconnected from the clock, the time display will automatically be set to 1:00 (one o’clock)
Other equipment
...
Power outlet
The power outlet is designed for power supply for car accessories. To use
the power outlet, open as shown in the illustration.
The key must be in the “ACC” or “ON” position for the powe ...
See also:
Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle.
■ Correct use of the seat belts
● Extend the shoulder belt so that it comes fully over the should ...
Dinghy towing (vehicles with a manual transmission)
Your vehicle can be dinghy towed in a forward direction (with 4 wheels on
the ground) behind a motor home.
Towing your vehicle with 4 wheels on the ground
To prevent damage to your vehicle, perf ...
Windshield wipers and washer
To turn on the windshield wipers, move the lever to the desired setting.
The key must be in the “ON” position.
Lever position
Speed setting
Position 1
Intermitt ...