Fit standards

...

Body panel sealing areas

HINT: 1) Prior to applying body sealer, clean the area with a rag soaked in silicone remover. 2) If weld-through primer was used, first wipe off any excess and than coat with anti-corrosion prime ...

See also:

If a warning light turns on or a warning buzzer sounds...
Calmly perform the following actions if any of the warning lights comes on or flashes. If a light comes on or flashes, but then goes off, this does not necessarily indicate a malfunction in the sy ...

Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle. ■ Correct use of the seat belts ● Extend the shoulder belt so that it comes fully over the should ...

If you have a flat tire
Remove the flat tire and replace it with the spare tire provided. ■ Before jacking up the vehicle ● Stop the vehicle on a hard, flat surface. ● Set the parking brake. ● Shi ...