Toyota Yaris: Turn signal lever - Driving procedures - When driving - Toyota Yaris XP130 2010–2025 Owner's ManualToyota Yaris: Turn signal lever

The turn signal lever can be used to show the following intentions of the driver:

Right turn

Left turn Right turn

Lane change to the right (push and Left turn

hold the lever partway) Lane change to the right (push and hold the lever partway)

The right hand signals will flash until you release the lever.

hold the lever partway) Lane change to the left (push and hold the lever partway)

The left hand signals will flash until you release the lever.

■Turn signals can be operated when

The engine switch is in the “ON” position.

■If the indicator flashes faster than usual

Check that a light bulb in the front or rear turn signal lights has not burned out.

    Manual transmission
    ■ Shifting the shift lever Fully depress the clutch pedal before operating the shift lever, and then release it slowly. If it is difficult to shift in reverse, shift the shift lever to N, r ...

    Parking brake
    To set the parking brake, fully pull the parking brake lever while depressing the brake pedal. To release the parking brake, slightly raise the lever and lower it completely while pressing th ...

    See also:

    Cleaning and protecting the vehicle exterior
    Perform the following to protect the vehicle and maintain it in prime condition: ● Working from top to bottom, liberally apply water to the vehicle body, wheel wells and underside of the vehi ...

    Winter driving tips
    Carry out the necessary preparations and inspections before driving the vehicle in winter. Always drive the vehicle in a manner appropriate to the prevailing weather conditions. ■ Pre-winte ...

    Seat belts
    Make sure that all occupants are wearing their seat belts before driving the vehicle. ■ Correct use of the seat belts ● Extend the shoulder belt so that it comes fully over the should ...