Toyota Yaris: Rocker outer panel (CUT-H): Hatchback 5 Door
REPLACEMENT
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram) Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
After welding, apply the polyurethane foam to the corresponding parts.
After welding, apply body sealer and under-coating to the corresponding parts.
After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.
Rear door outer panel (CUT): Sedan U.S.A., Canada
REPLACEMENT
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordance
with the body dimension diagram. (See the body dimension diagram) Inspe ...
Rocker outer panel (CUT): Hatchback 5 Door
REPLACEMENT
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordance
with the body dimension diagram. (See the body dimension diagram) Inspe ...
See also:
Tips for driving in various conditions
- Always slow down in gusty crosswinds.
This will allow you much better control.
- Drive slowly onto curbs and, if possible, at a right angle. Avoid driving onto
high, sharp-edged objects and othe ...
Handling precautions on related components
1. BRAKE SYSTEM
The brake system is one of the most important safety components. Always follow
the directions and notes given in the brake (32) section of the repair manual for
the relevant model ...
Power outlet
The power outlet can be used for 12 V accessories that run on less than 10
A.
■The power outlet can be used when
The engine switch is in the “ACC” or “ON” position.
NOTICE
■ ...