Toyota Yaris: Rear floor sidemember (ASSY): Sedan
With the rear floor pan removed.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram) Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
After welding, apply polyurethane foam to the corresponding parts.
After welding, apply body sealer and undercoating to the corresponding parts.
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
Cowl top side upper panel (ASSY): Sedan
REPLACEMENT With the cowl top side panel removed. REMOVAL INSTALLATION Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. ...
If a wheel is bent, cracked or heavily corroded, it should be replaced. Otherwise, the tire may separate from the wheel or cause a loss of handling control. ■ Wheel selection When replacing ...
Positioning the jack
When jacking up your vehicle with the jack, position the jack correctly as shown in the illustration. Jack position . Front—Front suspension member. Rear—Lower back outer panel. Support ...