Toyota Yaris: Positioning a floor jack - Do-it-yourself maintenance - Maintenance and care - Toyota Yaris XP130 2010–2024 Owner's ManualToyota Yaris: Positioning a floor jack

When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury.

Front

Rear

Rear

CAUTION

CAUTION

■When raising your vehicle

Make sure to observe the following precautions to reduce the possibility of death or serious injury:

●Lift up the vehicle using a floor jack such as the one shown in the illustration.

●When using a floor jack, follow the instructions of the manual provided with

●When using a floor jack, follow the instructions of the manual provided with the jack.
●Do not use the jack that was supplied with your vehicle.
●Do not put any part of your body underneath the vehicle when it is supported only by the floor jack.
●Always use floor jack and/or automotive jack stands on a solid, flat, level surface.
●Do not start the engine while the vehicle is supported by the floor jack.
●Stop the vehicle on level, firm ground, firmly set the parking brake and shift the shift lever to P (vehicles with an automatic transmission) or R (vehicles with a manual transmission).
●Make sure to set the floor jack properly at the jack point. Raising the vehicle with an improperly positioned floor jack will damage the vehicle and may cause the vehicle to fall off the floor jack.

●Do not jack the vehicle at the suspension. The suspension may be damaged.

●Do not jack the vehicle at the suspension. The suspension may be damaged.

CAUTION

●Do not raise the vehicle while someone is in the vehicle.
●When raising the vehicle, do not place any object on top of or underneath the floor jack.

    Hood
    Release the lock from the inside of the vehicle to open the hood. Pull the hood lock release lever. The hood will pop up slightly. Pull up the auxiliary catch lever and lift the hood. Hold t ...

    Engine compartment
    Fuse boxes (→P. 275) Engine oil filler cap (→P. 245) Battery (→P. 250) Brake fluid reservoir (→P. 249) Radiator (→P. 248) Condenser (→P. 248) Electri ...

    See also:

    Rocker outer panel (CUT): Sedan
    REPLACEMENT REMOVAL INSTALLATION Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram) Inspe ...

    Tips for driving in various conditions
    - Always slow down in gusty crosswinds. This will allow you much better control. - Drive slowly onto curbs and, if possible, at a right angle. Avoid driving onto high, sharp-edged objects and othe ...

    Front door outer panel (CUT): 3-Door
    REPLACEMENT REMOVAL INSTALLATION Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram) Inspe ...