Fit standards

...

Body panel sealing areas

HINT: 1) Prior to applying body sealer, clean the area with a rag soaked in silicone remover. 2) If weld-through primer was used, first wipe off any excess and than coat with anti-corrosion prime ...

See also:

Emergency flashers
To turn on the emergency flashers, push the switch. All the turn signal lights will flash. To turn them off, push the switch once again. Turn on the emergency flashers to warn other drivers if ...

Checking brake fluid
Before checking or adding the brake fluid, remove the cover. (See “(c) Jump starting”). To check the fluid level, simply look at the see-through reservoir. The level should be between the � ...

If the engine will not start
If the engine will not start even though correct starting procedures are being followed (→P. 124), consider each of the following points: ■ The engine will not start even though the sta ...