Toyota Yaris: Handling precautions on related components
1. BRAKE SYSTEM
The brake system is one of the most important safety components. Always follow the directions and notes given in the brake (32) section of the repair manual for the relevant model when handling brake system parts.
NOTICE: When repairing the brake master cylinder or TRAC system, bleed the air out of the TRAC system.
2. DRIVE TRAIN AND CHASSIS
The drive train and chassis are components that can have great effects on the running performance and vibration resistance of the vehicle. After installing components in the sections listed in the table below, perform alignments to ensure correct mounting angles and dimensions. Body repair must be particularly accurate to ensure correct alignment.
HINT: Correct procedures and special tools are required for alignment. Always follow the directions given in the repair manual for the relevant model during alignment and section DI of this section.
3. COMPONENTS ADJACENT TO THE BODY PANELS
Various types of component parts are mounted directly on or adjacently to the body panels. Strictly observe the following precautions to prevent damaging these components and the body panels during handling.
Before repairing the body panels, remove their components or apply protective covers over the components.
Before prying components off using a screwdriver or a scraper, etc., attach protective tape to the tool tip or blade to prevent damaging the components and the body paint.
Before removing components from the outer surface of the body, attach protective tape to the body to ensure no damage to painted areas.
HINT: Apply touch-up paint to any damaged paint surfaces.
Before drilling or cutting sections, make sure that there are no wires, etc. on the reverse side.
4. ECU (ELECTRONIC CONTROL UNIT)
Many ECUs are mounted in this vehicle.
Take the following precautions during body repair to prevent damage to the ECUs.
Before starting electric welding operations, disconnect the negative (−) terminal cable from the battery.
When the negative (−) terminal cable is disconnected from the battery, memory of the clock and audio systems will be canceled. So before starting work, make a record of the contents memorized by each memory system. Then when work is finished, reset the clock and audio systems as before.
When the vehicle has tilt and telescopic steering, power seats and outside rear view mirrors, which are all equipped with a memory function, it is not possible to make a record of the memory contents.
So when the operation is finished, it will be necessary to explain this fact to the customer, and request the customer to adjust the features and reset the memory.
Do not expose the ECUs to ambient temperatures above 80 C (176 F).
NOTICE: If it is possible the ambient temperature may reach 80 C (176 F) or more, remove the ECUs from the vehicle before starting work.
Be careful not to drop the ECUs and not to apply physical shocks to them.
Checking the radiator and condenser
If any of the above parts are extremely dirty or you are not sure of their condition, take your vehicle to a Toyota dealer. CAUTION. To prevent burning yourself, be careful not to touch the radiat ...
Cargo and luggage
—Stowage precautions When stowing cargo and luggage in the vehicle, observe the following: - Put cargo and luggage in the luggage compartment when at all possible. Be sure all items are secure ...
Using the interior lights
Interior lights list Personal lights (→P. 203) Interior light (→P. 203) Personal lights Turns the lights on/off Interior light Turns the lights off Turns the lights on/off ...