Toyota Yaris: Dinghy towing
with automatic transmission

Your vehicle is not designed to be dinghy towed (with four wheels on the ground) behind a motorhome.
NOTICE.
Do not tow your vehicle with four wheels on the ground. This may cause serious damage to your vehicle.
with manual transmission

Your vehicle can be dinghy towed (with four wheels on the ground) from the front behind a motorhome.
CAUTION.
Dinghy towing requires special equipment and accessories. Please refer to your service outlet of the motorhome manufacture for the recommended equipment.
NOTICE.
Dinghy towing does not eliminate the possibility of damage to your vehicle.
DINGHY TOWING TIPS
Before dinghy towing, be sure to observe the following in order to reduce the damage to your vehicle.
1. Put the shift lever in neutral.
2. Turn the ignition switch to the “ACC” position. Make sure the audio is turned off and any item is not plugged into the power outlet.
NOTICE.
To avoid the locking of the steering wheel, turn the ignition switch to the “ACC” position.
3. Release the parking brake.
After dinghy towing, let the engine idle for more than 3 minutes before driving the vehicle.

NOTICE.
Do not tow your vehicle from the rear. This may cause serious damage to your vehicle.
Winter driving tips
Make sure you have a proper freeze protection for engine coolant.
Only use “Toyota Super Long Life Coolant” or similar high quality ethylene glycol
based non-silicate, non-amine, non-nitrite, ...
Trailer towing
Trailer towing (except for Canada)
Toyota does not recommend towing a trailer with your Toyota. Toyota also does
not recommend the installation of a tow hitch or the use of a tow hitch carrier ...
See also:
When trouble arises
What to do if the vehicle needs to be towed, gets a flat tire, or is involved
in an accident. ...
Emission inspection and maintenance (I/M) programs
Some states have vehicle emission inspection programs which include OBD (On
Board Diagnostics) checks. The OBD system monitors the operation of the emission
control system.
■ If the malfunc ...
Body panel sealing areas
HINT: 1) Prior to applying body sealer, clean the area with a rag soaked in silicone
remover.
2) If weld-through primer was used, first wipe off any excess and than coat with
anti-corrosion prime ...