Toyota Yaris: Body panel anti-rust agent (wax) application areas
HINT: 1) Apply anti-rust agent (wax) around the hinges whenever adjusting the doors and hoods.
2) Even if partially repairing a part, apply anti-rust agent (wax) over the entire application area of the part.
3) Wipe off the anti-rust agent immediately with a rag soaked in silicone remover if it is accidentally applied to other areas.
Foamed material application areas
The sections shown in the figure below are filled with foamed material to provide
noise insulation.
Refill with foamed materials after repairing these sections and their surrounding
sections.
HI ...
See also:
Rear door outer panel (CUT): Sedan U.S.A., Canada
REPLACEMENT
REMOVAL
INSTALLATION
Temporarily install the new parts and measure each part of the new parts in accordance
with the body dimension diagram. (See the body dimension diagram) Inspe ...
Checking the engine coolant level
Look at the see-through coolant reservoir when the engine is cold. The coolant
level is satisfactory if it is between the “FULL” and “LOW” lines on the reservoir.
If the level is low, add ...
Engine exhaust cautions
CAUTION.
Avoid inhaling the engine exhaust.
It contains carbon monoxide, which is a colorless and odorless gas. It can cause
unconsciousness or even death.
Make sure the exhaust system has no hol ...