Toyota Yaris: Floor mat - Other interior features - Interior features - Toyota Yaris XP130 2010–2019 Owner's ManualToyota Yaris: Floor mat

Use only floor mats designed specifically for vehicles of the same model and model year as your vehicle. Fix them securely in place onto the carpet.

Insert the retaining hooks (clips) into the floor mat eyelets.

Insert the retaining hooks (clips) into the floor mat eyelets.

Turn the upper knob of each retaining hook (clip) to secure the floor mats in

Turn the upper knob of each retaining hook (clip) to secure the floor mats in place.

*: Always align the The shape of the retaining hooks (clips) may differ from that shown in the illustration. marks.

The shape of the retaining hooks (clips) may differ from that shown in the illustration.

CAUTION

Observe the following precautions. Failure to do so may cause the driver’s floor mat to slip, possibly interfering with the pedals while driving. An unexpectedly high speed may result or it may become difficult to stop the vehicle, leading to a serious accident.

■When installing the driver’s floor mat

●Do not use floor mats designed for other models or different model year vehicles, even if they are Toyota Genuine floor mats.
●Only use floor mats designed for the driver’s seat.
●Always install the floor mat securely using the retaining hooks (clips) provided.
●Do not use two or more floor mats on top of each other.
●Do not place the floor mat bottom-side up or upside-down.

■Before driving

●Check that the floor mat is securely fixed in the correct place with all the

●Check that the floor mat is securely fixed in the correct place with all the provided retaining hooks (clips). Be especially careful to perform this check after cleaning the floor.
●With the engine stopped and the shift lever in P (vehicles with an automatic transmission) or N (vehicles with a manual transmission), fully depress each pedal to the floor to make sure it does not interfere with the floor mat.

    Assist grips
    An assist grip installed on the ceiling can be used to support your body while sitting on the seat. CAUTION ■Assist grip Do not use the assist grip when getting in or out of the vehicle o ...

    Luggage compartment features
    ■ Deck board Removing the deck board Lift up the deck board and pull it towards you to remove it. Securing the deck board Lift up the deck board. Remove the hook on the backside ...

    See also:

    Replacing battery
    For replacement, use a CR2016 lithium battery or equivalent and a flathead screwdriver or equivalent. CAUTION. Special care should be taken to prevent small children from swallowing the removed ...

    Essential information
    Installing towing eyelet Type A Remove the eyelet cover using a flathead screwdriver. To protect the bodywork, place a rag between the screwdriver and the vehicle body as shown in the illustrat ...

    Body panel sealing areas
    HINT: 1) Prior to applying body sealer, clean the area with a rag soaked in silicone remover. 2) If weld-through primer was used, first wipe off any excess and than coat with anti-corrosion prime ...